PREFERIBILE VENDITA IN BLOCCO. IL TUTTO EUR 350,
Trattasi di due interfacce audio:
ECHODIGITAL Layla 24 96Khz 24Bit composta da unità rack e scheda pci v2
Caratteristiche:
8 balanced ¼" analog inputs with 110dB (A-weighted) dynamic range
8 balanced ¼" analog outputs with 115dB (A-weighted) dynamic range
MIDI in/out/thru
24 bit optical and coaxial S/PDIF digital I/O
ADAT optical digital I/O
Headphone output with volume control
Word clock I/O
Rack mountable single space breakout box
15' cable to connect to PC
128x oversampling analog-to-digital converters
Supports full duplex 16 channel in, 16 channel out operation
PCI or CardBus bus mastering interface
+4dBu or -10dBv analog I/O on each analog channel
Software console for monitoring, metering, and setting levels
Built-in digital mixer provides near-zero latency monitoring
Driver support for Windows 95/98/Me2000/XP and Macintosh OS 8/9/X (Jaguar & Panther)
Support for WDM, ASIO and GSIF
Low-latency drivers
Compatible with all popular recording products
PREZZO EUR: 200
RME DSP HAMMERFALL 9636/52 ADAT Bridge PCI
Caratteristiche:
2 x ADAT digital I/O, based on RME's reliable Bitclock PLL
1 x SPDIF digital I/O, based on RME's reliable DIGI96 technology
1 x ADAT Sync In (9-pin D-type) for sample accurate transfers
1 x Breakout cable for coaxial SPDIF operation
Zero wait state PCI Busmaster interface with additional burst FIFO (130 MB/s transfer rate in both directions)
No drop out problems at high PCI bus load
New hardware design: 36 mono channels in block mode, organized in 32 bit ASIO double buffers
ASIO poured in hardware! The result in speed and performance is 0 (zero!)% CPU load when using ALL 36 channels!
130 MB/s transfer rate for record and playback results in only 7% PCI bus load when using all 36 channels
New Enhanced Zero Latency Monitoring, now operational even with different sample rates at input and output
S/MUX poured in hardware: 8 channels 96 kHz/24 bit for record and playback
Supported sample frequencies: 32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
All settings changeable in realtime, all output options even in playback mode
Clock modes slave and master
Special sample buffer avoids noise even in asynchronous Full Duplex operation
Enhanced Mixed mode: ADAT® input plus SPDIF input plus all outputs simultaneous operational
Automatic and intelligent master/slave clock control
Unsurpassed Bitclock PLL (audio synchronisation) in ADAT® mode
8 buffer sizes/latencies available: 1.5 ms, 3 ms, 6 ms, 12 ms, 23 ms, 46 ms, 93 ms, 186 ms
Byte swap for Mac included in hardware
Enhanced Zero Latency Monitoring: realtime monitoring in all clock modes and even at different sample rates
Comes with DIGICheck: the ultimate measurement, analysis and test tool
Complete interrupt sharing
Input 2 x optical (TOSLINK), 1 x coaxial (Phono), internal (CD-ROM/Sync-In)
Input format SPDIF, AES/EBU (Consumer, Professional), ADAT® optical
Output 2 x optical (TOSLINK), coaxial (Phono), internal (Sync-Out)
Format output SPDIF, AES/EBU (Consumer/Professional), ADAT® optical
Auto Sync: Intelligent clock control according to operational mode and present/desired sample rate.
Bit clock PLL: The most reliable receiver circuit for ADAT optical signal.
Enhanced ZLM: Monitoring of the input signal, independent from clock mode and sample rate.
Hi-Performance: Custom chip (FPGA) ensures full performance and minimal driver action.
Latency Fast Change: Change latency on-the-fly under ASIO, without manual reset or re-boot.
SuperFast: Ultra-efficient busmaster controller with additional burst FIFO.
SyncAlign: Surveillance and sample accurate synchronization of all channels.
SyncCheck: Comparison and display of all input's clock status.
Zero Latency Monitoring (ZLM): Automatic monitoring of the input signal with zero latency.
PREZZO: EUR 200
ALEX : 331 3003315
Invio foto solo a interessati.
Accetto permute.
